I’ve been happily printing for a while now with my Wanhao Duplicator i3 using PLA but a recent problem has occurred wherein, during the initial stages of a print with a large base surface area, the first layer has not stuck to the raft. This produces a surface effect similar to the gills of a fish, where, in one direction, the surface bows and parts of the filament stick up proud of the raft about 3mm high, forming raised ridges open on one side, at regular intervals. This obviously greatly int
Troubleshooting! Prints Aren't Sticking to the Build Plate! : 5
UltiMaker Cura - Build plate adhesion settings
The correct resin 3D printing raft settings
First layer not adhering to raft - can anyone help? - 3D Printing
First Layer Adhesion / Warping Help with Specific Print - Improve
Cura First Layer Settings: Initial Layer Simply Explained
3D Printing Troubleshooting Guide
3D print not sticking to bed. Here are solutions!
Supports touching build plate starting on layer #2 · Issue #15388