Hi guys, I come to seek some knowledge. I have a couple of lines pointing towards a center, and I need to rotate them so that they face the white direction. This rotation must be according to the least rotation possible. I was not able to think of an appropriate criteria to use. I thought about comparing Angle and Reflex angle, but it is not enough: In the picture you can see that both reflex angles (blue) are larger than the actual angle (red), but the line in the upper corner needs to be
Speedo Katalóg 2020 Features Features Features-Polyester, 59% OFF
Speedo Katalóg 2020 Features Features Features-Polyester, 59% OFF
Full article: RoamFab: A Design Tool for Reconfiguring Parameterized Mechanisms to 3D Models With Structural Optimization
PDF) Grasshopper Primer V3-2 Антон Штанько
GrasshopperPrimer V3-3 en
Curve plane orientation - Grasshopper - McNeel Forum
Speedo Katalóg 2020 Features Features Features-Polyester, 59% OFF
Photopia for SOLIDWORKS and Rhino
Speedo Katalóg 2020 Features Features Features-Polyester, 59% OFF
GrasshopperPrimer V3-3 en
PDF) Grasshopper Primer V3-2 Антон Штанько
How to flip lines and curves so they're in a counter-clockwise loop - Grasshopper - McNeel Forum
Criteria to choose between clockwise and anticlockwise rotation of lines - Grasshopper - McNeel Forum
.jpg)
