Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This
SimScale - Another Fine Mesh
播放列表 playList-7a8e6569-bece-4ade-a8b7-ce0e91a38e0c
Boundary Layer Does Not Form - Except When Default Settings Used - Project Support - SimScale CAE Forum
Boundary layer not forming - Project Support - SimScale CAE Forum
Inflation problem
SimScale - Another Fine Mesh
Mesh study external aerodynamics problem - Project Support - SimScale CAE Forum
PDF) Independent Assessment and Benchmarking of no/low cost Finite Element Analysis Software for Linear Static Structural Analysis
Inflation Layer - Project Support - SimScale CAE Forum
Mesh inflation layer not shown - Project Support - SimScale CAE Forum
Inflation Layer - Project Support - SimScale CAE Forum
Mesh inflation layer not shown - Project Support - SimScale CAE Forum